4
[ubuntu] WPA2 Static IP gives the right IP but NO internet connectionview story

http://ubuntuforums.org – I don't know where to put this, or even what I'm looking for. I've tried for 6 hours today to get my WPA2 wireless to work as a static IP on my laptop to no avail. I've tried almost all the suggestions in this thread. Basically I put things in correctly (at least according to that thread) but I get no interent. (HowTos)

4
[ubuntu] Wired NIC Doesn't See New Routerview story

http://ubuntuforums.org – Switch actually. I bought a switch, connected it to our router, and moved the patch cords to the switch. All but one of the workstations connect & work fine. If I plug the non-connecting wire into my laptop it connects. (HowTos)

4
How to use USB modem with Ubuntu Serverview story

http://www.linuxquestions.org – Hi all, I am trying to set up one home networking lab in which I plan to use three routers. One of the router will be QUAGGA over Ubuntu Server. I cannot figure out how to setup my HSIA USB Modem (TataPhoton+ from Tata teleservices)in ubuntu server. This device works fine with Ubuntu 9.10 desktop edition. (HowTos)

4
[lubuntu] No wireless networks foundview story

http://ubuntuforums.org – I installed Lubuntu yesterday on an older Dell laptop and the installation went fine. The only thing not working after the installation was the wireless. (HowTos)

6
[ubuntu] Using PC as a Router to share internet: Laptop connects but Desktop PC doesn'tview story

http://ubuntuforums.org – Since I have 3 Network cards in my Desktop PC I've configured it to act as a Router using GNU/Linux Ubuntu Lucid in combination with Samba so I could share my internet connection. (HowTos)

4
unable to run wi fi on rhel 5view story

http://www.linuxquestions.org – hi ,iam vikrant initially i have problem how to start wi fi on rhel 5 then from some source i got a little bit knowledge but it is stil not working steps followed by me were: system/administrators/network network -configuration wizard opened here i did some steps which result into the following line [checked]active eth0 eth0 wireless then i click activate it gets activate as shown in the abov (HowTos)

4
[ubuntu] Ubuntu Server wont acknowledge my RJ45view story

http://ubuntuforums.org – Hi forum! My problem is that I recently upgraded my hardware for my Ubuntu Server (10.04.1 ver.) with a new motherboard ++ Then I plugged in RJ45 the at the very same location. But no blinking light from the RJ45 interface, and no connection with router.. The cable must be broken. So I tried the cable with my school laptop (linux Mint newes ver.) .. and it worked! (HowTos)

4
LXer: ASUS RT-N16 the Perfect Linux Routerview story

http://www.linuxquestions.org – Published at LXer: Before we get into it though, the topic of focus, the ASUS RT-N16, is a Gigabit and Wireless-N compatible router that uses a Linux kernel based firmware (essentially, the operating system) by default. The default firmware (or, operating system) on the router can be replaced with a different operating system (OS) such as TomatoUSB. Read More... (HowTos)

4
[ubuntu] wireless is incredibly slow - maverick fresh installview story

http://ubuntuforums.org – Hi, yesterday I did a fresh install with 10.10 on my notebook. Everything seemed to work fine, my ath9k wireless connected right away to my network. (HowTos)

4
[ubuntu] wicd 1.7 - wireless - Connection Failed: Bad Passwordview story

http://ubuntuforums.org – I switched to wicd a few months ago because it seemed to switch between wired and wireless very smoothly. It's been a while since I've used wireless and now when I try I get Quote: Connection Failed: Bad Password every the time. I know the password is correct b/c it is the pw I use everywhere on my laptop as well as the router and I am writing this on an old wi (HowTos)