6

[ubuntu] spacecam 120 problems

view full story
linux-howto

http://ubuntuforums.org – i have a spacecam 120 and tried to install it under the sn9c102 chipset, first installing the driver, followed by a supported program sonic-snap. after the cam not being detected i was advised to go into terminal and see if the device was successfuly installed, this is what i found, and have had no luck so far in gettting any response from the cam. dmesg | less [15690.933049] usb 2-2: new full speed USB device using ohci_hcd and address 3 [15691.143226] usb 2-2: configuration #1 chosen from 1 choice [15691.374761] Linux video capture interface: v2.00 [15691.389715] sn9c102: V4L2 driver for SN9C1xx PC Camera Controllers v1:1.47pre49 [15691.391154] usb 2-2: SN9C10[12] PC Camera Controller detected (vid:pid 0x0C45:0x600D) [15691.589056] usb 2-2: PAS106B image sensor detected [15692.259265] usb 2-2: Initialization succeeded [15692.259400] usb 2-2: V4L2 device registered as /dev/video0 [15692.259406] usb 2-2: Optional device control through 'sysfs' interface disabled [15692.259447] usbcore: registered new interface driver sn9c102 [15692.285224] usb 2-2: usb_submit_urb() failed, error -28 [15692.358067] ohci_hcd 0000:00:0b.0: leak ed f642c100 (#81) state 2 if anyone can help please do! (Hardware)