3

[ubuntu] problem assigning a static IP to a LAMP/SSH server?

view full story
linux-howto

http://ubuntuforums.org – I'm trying to set up a server to have one network card using DHCP, and the other using a static IP, but when I run: Code: sudo /etc/init.d/networking restart to bring up the network interfaces, I get an error: Code: SIOCADDRT: No such process Failed to bring up eth1 Here's my network interface file from that system: Code: # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback (HowTos)

xskl's picture
Submitted by xskl on 07/17/2010 – Made popular on 07/17/2010

Stories similar to [ubuntu] problem assigning a static IP to a LAMP/SSH server?

Hey all,

I'm having a really odd issue.

I just upgraded my 11.11 server to 12.04, by performing a clean install.

I edited my /etc/network/interfaces file to the following:

Code: # This file describes the network interfaces available on your system # and how to activate them.

Hi !

I follow instalation from here wiki.ubuntu.com/ServerTeam/MAAS and I decide to do something like this: [Attached file] And on MaaS server i install dnsmasq and make it DHCP server.

I leave this blank. And in etc/network/interface I have this:

Code: # This file describes the network interfaces available on your system # and how to activate them.

Have a 'new' mailserver running postfix on Ubuntu.

We are having some problems configuring the subnets & interfaces.

Basically 2 subnets (.253. & .254.) need to be connected through the 3rd subnet (.252.) where the Router is residing.

# This file describes the network interfaces available on your system # and how to activate them.

I am running Ubuntu Server 12.04. I have a wireless USB card. When I begin the boot process I see:

Waiting for network configuration

It turns out that the network never comes up. But once I get to the command line, if I type: ifup wlan0, then I have network access.

Hi All,

I have 2 NICs in my U9.04 Server box (eth0, eth1). After I added 2 virtual interfaces for each physical interface (eth0:1,eth0:2,eth1:1,eth1:2), the MAC addresses of all the interfaces have changed to that of eth0. Because eth1 was configured to be on my local network, I can't access the box remotely anymore.

/etc/init.d/networking 38 weeks 2 days ago

Hello Crunchbangers,In Wardorf, I set up a virtual IP address as follows (FYI, I need it for MPD's config file mpd.conf):sudo vi /etc/network/interfacesand put this code in # The loopback network interface auto lo iface lo inet loopback

# virtual IP address for MPD auto wlan0:1 iface wlan0:1 inet static address 192.168.1.66 netmask 255.255.255.0 network 192.168.1.

I'm wondering if I've found a bug in ifupdown, but I wanted to ask here before reporting a bug:

/etc/network/if-up.d/upstart seems to fail to emit static-network-up if any virtual interfaces are defined.

I have 3 network cards installed in my ubuntu 10.04 server and I want to configure Internet sharing and file sharing on eth1 for wired users and wlan0 for wireless users.

Static ip: eth0: 192.168.1.1 eth1: 10.0.0.15 wlan0: 10.0.0.20

/etc/network/interfaces

# The loopback network interface auto lo iface lo inet loopback

# The primary network interface auto eth0 iface eth0 inet static address 19