When I run Wireshark, It shows the following message:
Couldn't run /usr/sbin/dumpcap in child process: Permission denied
Are you a member of the 'wireshark' group? Try running
'usermod -a -G wireshark _your_username_' as root.
I ran this command: usermod -a -G wireshark myusername and checked my groups using groups myusername and I was added to the wireshark group.
Hi,Recently I've tried to install wireshark. I wanted to use it from my everyday user. However I encountered a problem during the installation Failed to set capabilities on file `/usr/bin/dumpcap' (Operation not supported)
usage: setcap [-q] [-v] (-r|-|<caps>) <filename> [ ...
I m going to install wireshark from the following youtube video
http://www.youtube.com/watch?v=_YYEIV35IlE
sudo apt-get install wireshark libcap2-bin
sudo groupadd wirshark
sudo usermod -a -G wireshark debbase
But I faced problem while I ran the command sudo usermod -a -G wireshark debbase. It gives the error:
user 'debbase' does not exist
What should I do?
Install wireshark and added it to visudo.
But wireshark refused to start in konsole
Code:
# sudo wireshark
(wireshark:7493): Gtk-WARNING **: cannot open display:
However, wireshark will start without problem when in root.
I've installed Wireshark and configured it to let my user run it with all needed privileges (I enabled dumpcap and added my user to wireshark group, then restarted).
Devices are shown and capture starts well. The problem is that only packets sent to and directed to the PC where Wireshark is running are captured.
Hi Everyone,I am running Wireshark 1.8.1 (compiled from source) under CentOS 6.3.I am running Dumpcap as a service.Dumpcap command command line is:/u... [by xq1xq1]
Wireshark, one of the foremost network protocol analyzers offering users the means to capture and interactively browse the traffic running on a computer network, is now at version 1.8.6.
The current version of Wireshark, 1.8.6, supersedes all previous releases, including all releases of Ethereal.
Highlights of Wireshark 1.8.6:
• HTTP application/json-rpc is now decoded/shown as application
Wireshark, one of the foremost network protocol analyzers offering users the means to capture and interactively browse the traffic running on a computer network, is now at version 1.8.4.
The current version of Wireshark, 1.8.4, supersedes all previous releases, including all releases of Ethereal.
Wireshark does co... (read more)
{lang: 'en-GB'}
Wireshark is the world’s foremost network protocol analyzer. It lets you capture and interactively browse the traffic running on a computer network.
Email this page
