I have debian hosts which are connected through trunk port on 5 different vlans. But this host respond to arp "who-has" requests of all of their differents ip.
Hey all,
I'm having a really odd issue.
I just upgraded my 11.11 server to 12.04, by performing a clean install.
I edited my /etc/network/interfaces file to the following:
Code:
# This file describes the network interfaces available on your system
# and how to activate them.
I have an Ubuntu Server 10.04.1 that I have given a static IP address. Every six hours or so I will lose connectivity to it and when I type ifconfig to look at the network information, it has been given an address via dhcp. If I run the /etc/init.d/networking restart command the IP address goes back to my static address and things are fine for another 6 hours or so.
I've setup Ubuntu server along with ufw as a firewall.
To start, I have two networks:
Public: 66.xxx.xxx.70 - 66.xxx.xxx.78
Private: 192.168.3.1 - 192.168.3.255
My network config:
auto eth0
iface eth0 inet static
address 66.xxx.xxx.70
netmask 255.255.255.0
network 66.xxx.xxx.0
broadcast 66.xxx.xxx.255
gateway 66.xxx.xxx.1
auto eth0:0
iface eth0:0 inet
Hi All,
I have 2 NICs in my U9.04 Server box (eth0, eth1). After I added 2 virtual interfaces for each physical interface (eth0:1,eth0:2,eth1:1,eth1:2), the MAC addresses of all the interfaces have changed to that of eth0. Because eth1 was configured to be on my local network, I can't access the box remotely anymore.
I'm wondering if I've found a bug in ifupdown, but I wanted to ask here before reporting a bug:
/etc/network/if-up.d/upstart seems to fail to emit static-network-up if any virtual interfaces are defined.
I have an ubuntu box handling DHCP and DNS on my network.
I have eth0 set to static for my internal network and eth1 set to DHCP and connected to my cable modem.
For testing purposes I installed virtualbox to simulate a linux(64 bit ubuntu) server.
I configured my network settings like this:
Adapter 1:
NAT
Adapter 2:
Host-only
with my etc/network/interfaces configured like this:
#loopback network interface
auto lo
iface lo inet loopback
# primary network interface
auto eth0
iface eth0 inet dhcp
#the host-only network interface
auto eth1
iface eth1 in
Hi
I'm trying to set up Clonezilla on a fresh Ubuntu install, following this tutorial:
http://geekyprojects.com/cloning/set...ver-on-ubuntu/
It mostly works out ok, but i have some problems setting up the virtual network card.