1

Support Replacing Logic Board

view story
linux-howto

http://androidforums.com – So my power button has stopped working, rendering my e4gt near useless. Since the power button is soldered to the logic board, i figured i would try to find a used e4gt and use the logic board. I found one with a broken screen on my local craigslist for $50. My question: Will the new logic board work in my phone? Will I need to do anything else service/carrier related after replacing the logic board or will i still retain my same number? (General)

Gnicqi's picture
Submitted by Gnicqi on 09/20/2012

Stories similar to Support Replacing Logic Board

Pano Logic loves its customers and loves its partners, so how can it turn that love into a giant cornucopia of channel adoration? It’s simple, now that Pano Logic has created a VP of Customer Success position.

I've used a given board configuration to reconfigure it for my individual board. My board has a CS4270 sound device of Cirrus Logic. My uImage is booting successfully on my target hardware, but an alsactl init always shows me no sound card. I loaded as many sound modules as I can, e.g. modprobe snd-soc-cs4270.

While studying about booting an android on any board, I have learnt that MLO(X-loader), U-boot and uImage are necessary to boot the android on board.

But I wondered that when I have come to know about that, the IMX53quickstart Board does not need MLO to boot an android on it.

1.How can it possible? How can the board boot without MLO?

2.Is this board have any special feature?

All computers use logic gates that have just two states 0 and 1. Has it been attempted to use logic gates that have more the two states? What would be the pros and cons of such a machine if ever made? One advantage that I can think of is that a 32 bit machine would be able to access a lot more RAM than it can with 2 logic states. Also smaller RAM would have a lot more memory.

Just wanted to understand what is the logic being used by Solaris(kernel) to transmit data/traffic on physical interfaces.

I have seen most of the time traffic is being sent to interface ce0 and sometime to ce1.

I have removed ip address from below command for some reason.

netstat -rn

Routing Table: IPv4 Destination Gateway Flags Ref Use Interface -------------------

hardware: Cavium octeon cn5010 based board A & board B, two boards networking as below: board A eth1 <----> board A eth0 <-------> board B eth0 <-----> board B eth1 <-----> PC

software: Cavium SDK 1.7.3, linux 2.6.16.45

Hello, I am havinf pegantron freescale processor board with me. I am trying to develop an application on that. so from where can i get support for this board?is there any active community for this board. i searched in google but i didnt find any answers. so please tell me where can i get help for this freescale board?

freescale processor help 3 years 22 weeks ago

Hello, I am having pegantron freescale processor board with me. I am trying to develop an application on that. so from where can i get support for this board?is there any active community for this board. i searched in google but i didnt find any answers. so please tell me where can i get help for this freescale board?

where is mpt-status 21 weeks 1 day ago

Hi, I'm trying to locate mpt-status.  I have an lsi raid card and I need mpt-status to be able to configure the raid card.[slimg00dy@slimg00dy ~]$ /usr/sbin/lspci -v | grep -iE 'sas|raid' 03:00.0 IDE interface: Marvell Technology Group Ltd.