Hello, I bought used 8800pro, the seller told me that he upgrade it to version 2.35 but he is not sure if he did it correct...When check the phone was working and all was fine, but I did not check wifi. At home whenever I try to connect to wifi it shows : fail. It does not show list of net at all. I even restore factory , but nothing is helping.
I was on stock image and everything was just fine.
Then I flashed Omega 8.0(4.1.2 base) and whenever I try to connect to Wifi with WPA-PSK or WPA-PSK2 i get authentication error occured whereas my other mobile phones and laptops are connecting to it without any problem.
To remedy the problem I reverted back to stock but the problem still exists.
Any suggestions ?
Help! My wifi use to connect fine for the first few months of having my phone, however now it just says "authentication problems" while trying to connect. I have for sure typed the password in correctly, i have tried forgetting the network and trying again, tried restarting my phone, tried resetting the rowder and nothing seems to be working, my other wireless devices connect fine
I am having a problem with my Wifi.
When I try to connect to a wifi network, and the first time it connects fine, and stays connected.
But if I leave, or disconnect, then it won't re-connect ever again. It spends about 2 minutes searching/connecting and then I get an error message saying:
"Attention
Network Disabled.
I've bought the phone just over a month and a half ago, it is in good condition even in a protective case, it has worked flawlessly up until this evening.
I was able to "send" my texts but other would not receive them, I too wasn't receiving texts from anyone.
Here's the problem:
1. factory refurbished nc wouldn't ever connect to my home wifi since 1st day,said mine out of range, but would connect to others around me
2. got new router, same problem, but could still connect to others around me
3. added android 2.2 w/n2a sdcard - same problem
4. called b&n 2 days ago, they had me upgrade to newest update for nc.
5.
Hi everyone im new too crunchbang, and I've been strugling to get internet via wifi.First I go into "edit connection" and I create a new wifi connection.
Hey guys, i was fed up after i can't connect to wifi using ubuntu. the problem happened after my router is being replaced to a new one because the old one got struck by lightning. good thing i dual-boot my laptop so i can access the internet using Windows 7 now.
i use the default network manager to connect to wifi before, but it all seem to be failed after the replacement of router.
For some reason I am unable to connect to my home WiFi network. It acts as if it is about to connect by saying authenticating and then stops and does not connect act all. Then after if I try to connect to the network again it says "Failed to connect to network". I have noticed this has happened to me before when I flashed the Viper ROM so I just went back to stock.
Email this page
