stqn wrote:mamamia88 wrote: My .xinitrc reads exec udiskie & startxfce4You’re supposed to exec startxfce4, not udiskie.as per the wiki page Start the Udiskie service by adding udiskie & to your xinitrc file, before the window manager is loaded." anyway i managed to get autmounting consistenly (for now) apparently just by following the advice https://wiki.archlinux.org/index.php/
The ArchLinux Wiki has the best documentation available and with the problems you describe here, if it does not suffice, ArchLinux is likely not for you.Everyone can install ArchLinux and most can use it, but it does require more from the user than Ubuntu and such.https://wiki.archlinux.org/index.php/The_Arch_Wayhttps://wiki.archlinux.org/index.php/Beginners%27_Guide
Network and Xorg issues sounds to me like you did too much in one go.https://wiki.archlinux.org/index.php/Be … leshootingCheck the connection, check the driver status and load the module: https://wiki.archlinux.org/index.php/Ne … figurationIf the network interface doesn't show up (eth0), read this part: https://wiki.archlinux.org/index.php/Ne … Interfaces
Things should be working as outlined in the wiki: https://wiki.archlinux.org/index.php/Sy … managementIf you think it's important, you can add a line about halt, although it's already mentioned in systemd FAQ https://wiki.archlinux.org/index.php/Sy … r_stays_onThere's also https://wiki.archlinux.org/index.php/Al … o_ShutdownObviously you can use an alias e.g.alias halt='sudo sy
Start by installing the appropriate video drivers.https://wiki.archlinux.org/index.php/Intelhttps://wiki.archlinux.org/index.php/AtiAlso see: https://wiki.archlinux.org/index.php/hy … e_GraphicsI have searced and found in some forum posts that AMD catalyst is not compatible with xorg-1.15.Therefor I'd try the open source one first, see link above.
With 'user' option it should mount OK.If you have gvfs installed, you have polkit, so check if the session is active: https://wiki.archlinux.org/index.php/Ge … ermissionsNot sure if https://wiki.archlinux.org/index.php/Xf … le_Devices has any useful info.
karol wrote:These steps are mentioned in the wiki: https://wiki.archlinux.org/index.php/Ibus#Initial_SetupIndeed. Please don't necrobump threads: https://wiki.archlinux.org/index.php/Fo … Bumping.27Closing
See the Wiki page for PulseAudio: https://wiki.archlinux.org/index.php/PulseAudioAnd under installation note pasystray-git. That is an AUR package so you will also want to read up about https://wiki.archlinux.org/index.php/Makepkg and probably want to be familiar with an AUR helper as well. I use https://aur.archlinux.org/packages/cower/ as an AUR helper and think the world would be a