Linux newbie here, anyway so here is the problem, I run Ubuntu 10.10 and I have a Sitecom 300N x2 Wireless Network dongle with chipset 8192SU, I used ndiswrapper to install my Windows Wireless driver because Sitecom doesn't have a linux driver, it says hardware present but it doesn't find any Wireless networks, nor does it connect to one.
I want to use my window driver in Ubuntu, because the ubuntu driver doesn't activate. When I install the driver (broadcom bcm43) a window pops up: Unable to see if hardware is present. Then I click OK. Then underneath the driver is the text: Hardware present: yes. But it doesn't work.
Hi,
Hello,
I am new to Ubuntu but quite familiar with computers / hardware / networking in general.
Hey everyone,
I just downloaded Ubuntu and installed fine, installed Ndiswrapper for my 050d:6050 device, aaaand it doesn't work. It's not obvious either when I type Ndiswrapper -l because it says, as you can guess from the title....
Code:
bcmwlhigh6 : driver installed
Device (050d:6050) present
So if someone could help me out with that, that would be great, Thanks.
Hi,
I am a newbie, who's trying to migrate from windows to ubuntu 13.04.
However, i cannot get my wireless usb stick (sitecom n150) runs properly.
I have tried to follow the installation guide, and successfully installed the driver to my desktop (i check via the command "ndiswrapper -l" and get the response "net8192su: driver installed and device (0df6:006b) present".
Howeve
Hello. I've read a lot about wireless network cards but I haven't found something similiar to my problem. I've a belkin wireless card F5D7000tt and its driver bcmwl5.inf. I think I've correctly installed it because when I use "ndiswrapper -l" i get:
WARNING: all config files need .conf: /etc/modprobe.d/ndiswrapper, it will be ignored in a future realease.
Let me start by saying I've yet to have a problem with any Broadcom card until now. It either just works, or needs Ndiswrapper or b43cutter to work.
I just got an Acer Aspire 3003WLMi laptop and tried installing 9.04. After the install, wireless didn't work at all. Tried Ndiswrapper with the correct Windows driver. Nothing.
I identified the device ID of my USB Wi-Fi dongle...
[root@localhost benny]# lsusb
Bus 001 Device 002: ID 1385:4251 Netgear, Inc WG111T (no firmware)
I downloaded a recommended driver and proceeded to install it on ndiswrapper, then I checked it was successful...
[root@localhost ndis5]# ndiswrapper -l
athfmwdl : driver installed
device (1385:4251) present
netwg11t : driver installed
Email this page
