Environment: Ubuntu Server 12.04, installing from bootable flash drive
Error: No root file system is defined. Please correct this from the partitioning menu.
I'm trying to set up a personal file server with software RAID 5. I just got three hard drives for this, but haven't found any solid documentation. I'm unsure what the basic way to partition my hard drives is.
Did you open the correct ports in the iptables firewall on the Linux machine? If you changed the host file entry on the Windows machine to point "centos-1" to a different IP address then ... [by TrevorH]
Environment: Ubuntu Server 12.04, installing from bootable flash drive Error: No root file system is defined. Please correct this from the partitioning menu.
I'm trying to set up a personal file server with software RAID 5. I just got three hard drives for this, but haven't found any solid documentation. I'm unsure what the basic way to partition my hard drives is.
I am trying to install Centos 6. Can't seem to get the allocations correct.I created an ext4 partition with "/" and set it to 2016.I then created a swap file of 200... [by shankle]
I am planning to use an Ubuntu Server 12.04 with KVM to create 2 virtual machines.
Reading some docs on the net, I have found that a good approach is to use LVM based VM, so my idea is to have:
1 ext2 partition for boot
1 LVG with 3 logical volumes: 1 for host, 1 for vm1 and 1 for vm2
Is this a good partitioning scheme? What factors do I need to consider?
I have set up hardware raid 1 with two SAS drives using the Adptec 6405E controller. I am having a problem when installing Ubuntu 10.04 LTS as it hangs at 43 % when partitioning disk drives. So far my Googling suggests that Ubuntu does not scan raided drives well. What can I do to finish my installation?
I have set up hardware raid 1 with two SAS drives using the Adptec 6405E controller. I am having a problem when installing Ubuntu 10.04 LTS as it hangs at 43 % when partitioning disk drives. So far my Googling suggests that Ubuntu does not scan raided drives well. What can I do to finish my installation?
About to start a home server build, primary purpose will be to serve as a NAS to windows 7 network plus an XBMC based HTPC (yet to be built).
I'm planning on installing ubuntu server 12.04, create some samba shares and run FlexRAID. I want to store media files on this NAS primarily. Don't plan on doing much of anything else at this point.
I am attempting to upgrade my compaq dl360 g1 to centos 6.3....5.8 was working on there previously. During the install it does not recognize the disk so I looked all day but could not find a soluti... [by cookem]
Email this page