Hello!We have a CentOS 6 x64 on a HP PROLIANT DL120 G7 with 2 1TB hard drives.The install was done with the RAID controller disabled and took only 1 drive.We have enabled th... [by jlambert]
on 04/17/2012 – Made popular on 04/17/2012
After I have enabled RAID I disabled the B110i raid controller in the BIOS. Now it is stuck on a POST message and I can't do anything. Pressing F9 to re-enter the BIOS settings does nothing. It remains stuck there... The server is remotely managed through ILO3. How can i do a BIOS reset or any solution without manual intervention?
I plugged a Q-Tec 340R ATA-133 IDE RAID card, with two IDE connectors and support for up to four IDE drives, into an old P4 machine, attached two hard drives and managed to set up RAID0 and install Fedora.
Hi. I am new to the server world and I just installed Centos 6.3 on my Dell PowerEdge 2850. I set up two RAID 1's using the server's RAID controller (Perc 4e). So I have 2 146 GB HDDs in ... [by Nameo0]
Depends. Is it a true hardware RAID with a supported controller? It would likely be easier to install CentOS on a <2TB drive and then add the RAID as additional storage, as Trevor suggested. U... [by pschaff]