I designed 10KVA Half Bridge Based Inverter ,for which specification are as follows,
Switching Frequency =10KHz
Bus Link Capacitor Voltage =800VDC MAx across Half Bridge
But i am confussed with the RC snubber across MOSFET to be used for one or both MOSFET ?
Also which ultrafast diode to be select for anti parallel connection across gate resistor?
I am new to blogging so please be patient. Also, please give me any critiques or directions that may help me.
I am a typical electronics amateur. I know more than some and a lot less than others.
I am currently needing information on single phase ac motors. Is there such thing as a single phase reversible, 2 speed motor? If so who makes it?
I am currently in the process of designing a very small wind turbine (only 45x45x45 cm). I am in the need of a 3 phase rectifier. I must produce a 5 volt potential difference across a variable load at all times while maintaining at least 10 W of continuous power. Thus, at least 2 A must also be produced.
i want to implement hardware for 3 phase sine wave inverter from single phase supply and also want to speed control of I.M.
all this implemnetation analog design(using opamp) and not using microcontroller
please help me.......
I have a 3 phase irem rectifier and I was wondering whether it would be possible to make a single ph rectifier out of it? I don't mean convert the existing unit As I believe that could be done with large caps but would it not be possible to cannibalise it and make a single ph 230 v rec? The unit powers a xenon lamp house on a cinema projector. Thanks