6

Marvell Ethernet Install sk98lin driver

view full story
linux-howto

http://forums.fedoraforum.org – I downloaded the sk98lin driver off the Marvell website, the one for Fedora Linux 2.6 and I am trying to get it to work with the following device. so lspci shows 02:00.0 Ethernet controller: Marvell Technology Group Ltd. Device 2a08 (rev 03) lsmod shows sk98lin 142216 0 The driver install also went off with out a hitch. It found no errors and at the end said to run modprobe sk98lin to manually load the driver. I tried that but still have no network functionality. Is this like ndiswrapper and I have to make an association between the driver and the device? Any help is welcome. I also already tried ndiswrapper but would like to use the right driver and not the WNT511 Netmax one. It seems this issue has been visited a couple of times in the past with a F3 forum and again on F4 but each does not provide information on how to fix the problem. Apparently an upgrade to F4 will do it. But I am running F12 so that does not make very much sense. (HowTos)