1

The installer is unable to run in graphical mode

view story
linux-howto

http://www.linuxquestions.org – While trying to run a GUI installer package, I get this message Application aborted with exit code 236. The installer is unable to run in graphical mode. This is a new RHEL 6.3 host I installed a host of libraries to attempt to resolve the issue. I confirmed that xclock works fine. The same installer works fine on RHEL 5.4 though the application supports only RHEL 6.x and higher. I ran a strace on the install process. But the file is too large (> 20 MB) to attach here. I have put some lines around where the error occured below. Honestly, the strace did not make much sense to me. If som (HowTos)