Install GRUB2 on USB from Ubuntu Linux

I recently upgraded my system from Fedora 14 to 16 by http://fedoraproject.org/wiki/Upgrad...dora_using_yum . All went quite smoothly except for one very odd problem. As you know this upgrade switches from grub to grub2. I created /boot/grub2/grub2.cfg with grub2-mkconfig and ran grub2-install without encountering any errors but when I restart I am taken to the grub prompt.

Hi ,

I'm new in Linux and would try some distris and/or RC of Fedora.

For Linux/Fedora I dispose a 750 GB drive.

Hi all,

Any idea why the DVD media is using grub as its bootloader and then installing it to disk instead of grub2?

I accidentally deleted every thing from grub2 customizer including command line everything now i cannot boot in fedora 17 please help i can only boot into recovery mode and tried following chroot /mnt/sysimage grub2-install /dev/sda grub2-mkconfig -o /boot/grub2/grub.cfg

but still nothing happens

i had also attached where i get stuck in boot kindly tell me how to completely unistall and

I'm running Linux on a 8,3 2011 MacBook Pro. It uses EFI/rEFIt to boot.

I was able to install GRUB2 EFI support, and it shows up just fine in the rEFIt boot menu.

Hello,I have a lot of problems with Grub2 and it is too complicated for me. I would like to install the old fashioned Grub.But when I follow these instructions https://help.ubuntu.com/community/Grub2 #Uninstalling GRUB 2 I stick at the "sudo aptitude install grub" point. I can't install grub. Every time I try, he installs the "new" Grub2.

So I just did a clean install of windows 7 ultimate and installed ubuntu 12.10 beside it. I kept the windows bootloader in the mbr at the advice if my tutorial (i used easyBCD to enable an option for grub2) and installed grub2 to the /boot partition that I made for sda5. If it matters, I set / as sda6, /home as sda7 and swap as sda8.

I've installed grub2 because my partition is no longer supported by the legacy grub but I can't make it display a text menu like in the legacy grub? When I start my pc it gives me the CLI where I need to manually load my configfile? Hence my config file is good but how I can start it automatically with grub2?

.... would I be right in running the following commands?

Code: grub2-install ## Then mount all my partitions since I've got 2 other OS's on this computer grub2-mkconfig -o /boot/grub2/grub.cfg Thanks, JamesNZ