4

How to enable printk message on EP9307 (kernel 2.6.8.1)

view full story
linux-howto

http://www.linuxquestions.org – Hi Guys, Can some one please show how to enable printk KERNEL_INFO messages to appear on serial terminal. I am trying to change the lcd device driver ep93xxfb.c So i have add some printk messages in the exsisting driver to see the current configuration of the lcd. The existing ep93xxfb.c has printk command but nothing is displayed on com port. I just get this on the terminal ---------------------------------------------------------------------------------------------------------------------------------- + Ethernet eth0: MAC address 00:00:00:00:68:34 IP: 192.168.254.10 0/255.255.255.0, Gateway: 192.168.254.254 Default server: 192.168.254.254, DNS server IP: 192.168.254.254 RedBoot(tm) bootstrap and debug environment [ROMRAM] Non-certified release, version v2_0 - built 10:15:31, Feb 5 2010 Platform: Cirrus Logic EDB9307 Board (ARM920T) Rev A Copyright (C) 2000, 2001, 2002, Red Hat, Inc. RAM: 0x00000000-0x04000000, 0x00041f68-0x03fbd000 available FLASH: 0x60000000 - 0x62000000, 128 blocks of 0x00040000 bytes each. == Executing boot script in 1.000 seconds - enter ^C to abort RedBoot> fis load ramdisk.gz RedBoot> fis load zImage RedBoot> exec -r 0x800000 -s 0xC00000 Using base address 0x0008 0000 and length 0x0012f580 Uncompressing Linux......................................... ............................................ done, booting the kern el. Please press Enter to activate this console. ---------------------------------------------------------------------------------------------------------------------------------- Thanks in advance. (HowTos)