I make many service in Centos 6.3 so I clone and copy any edition to do, but I don't see a NIC eth0, What I have to do to used eth0 ?, and how to create it ?
It some picture:
I've just installed Centos 6.3 and I'm having trouble with my eth0 connection.
After I installed Centos 6.3 there was no eth0 file, so I made one.
inside my eth0 file I have:
DEVICE=eth0
IPADDR=xxx.xxx.x.xxx
NETMASK=xxx.xxx.xxx.x
ONBOOT=yes
BOOTPROTO=static
HWADDR=xx.....
NM_CONTROLLED=no
When I run the cmd
# service network start
it brings up the loopback interface and the eth0 interface
just installed a fresh centos-minimal and i can not get bridged network to work or any of the networks not even in host-only mode. when you run ifconfig there is no eth0 only a lo,
also when you cat /etc/sysconfig/network-scripts/ifcfg-eth0
DEVICE="eth0"
HWADDR="08:00:27:FE:D5:10"
NM_CONTROLLED="yes"
ONBOOT="no"
The instructions for setting up a LAN, which I assume would allow me to create a sub-domain on my VPS, are the following using the command-line on CentOS:
Using sudo, create the configuration file /etc/sysconfig/network-scripts/ifcfg-eth0:0 with the following:
DEVICE=eth0:0
BOOTPROTO=none
ONPARENT=yes
TYPE=Ethernet
IPADDR=$ADDITIONAL_IP$
NETMASK=255.255.255.0
GATEWAY=XXX.XXX.XXX.1
NAME=eth0:
hello, i have:
eth0 with 192.168.1.0 subnet
and
eth0:0 with 192.168.30.0 subnet
From eth0 i can only permit samba connections to eth0:0
From eth0:0 i can only permit http connections to eth0
Should i create another zone?
help on this pls
Also, second question.
I have always worked with ethernet cards, but now i want to expand and i usually hear about pppX devices...
can someone explain me ab
I have a Centos 5.6 VM (Vsphere client) already responding to two different public IPs on eth0 and eth0:1 and I'm trying to add eth0:2.
I was messing around with KVM in CentOS 6.3 when I noticed I was having problems with the IP address of my principle network connection (eth0). I backed out my bridge
and restored the network-script file for eth0 but the IP address still goes missing after reboot. At this point I have to return to the console and restart the "network" service.
I have 2 addresses one on eth0 one on eth0.1.
How would I go about adding 3 IP's to my eth0.
When I tried the following, the whole network crashed.
ifconfig eth0 192.95.22.105 netmask 255.255.255.0 gateway 198.27.64.254
How would I go about adding more IP's to my CentOS server?
Email this page
