5

Grub2 Command Line Restarts On Any Command

view full story
linux-howto

http://serverfault.com – I've been attempting to configure a software raid1 using a pre existing Ubuntu 12.04 install by following the guide here. I successfully completed step 4 but then couldn't get Ubuntu to boot into the degraded raid device. I read somewhere that you need to run the following command dpkg-reconfigure grub-pc from within the raid config, so as root, after step 4 I ran the following commands: mkdir /tmp/mntroot mount /dev/md0 /tmp/mntroot chroot /tmp/mntroot dpkg-reconfigure grub-pc this appeared to correctly update the grub.conf to the new raid setup. On boot I can bring up the grub boot li (HowTos)