I am attempting to upgrade my compaq dl360 g1 to centos 6.3....5.8 was working on there previously. During the install it does not recognize the disk so I looked all day but could not find a soluti... [by cookem]
on 12/12/2012 – Made popular on 12/12/2012
I have a Compaq DL360 with two P3/933 Mhz CPUs and 1152 MB RAM running Windows 2003. Device manager shows a yellow ? with PCI Memory Controller. I understand that to be the remote access PCI card although everything seems to be working. Can I get a driver for it?
At first I thought this was a fluke, but I've now built well over 50 of these servers and I can't seem to find a solution. We are deploying HP DL360 G7's. Before you used to be able to hit F8 during boot up to enter into a ROM based setup utility for iLO. However now it simply shows a mention of iLO during POST, but you don't get a chance to press F8.
I just got my old DL360 G4 out of my closet, and I booted it up. It got into POST and then started beeping a lot, then displayed a fan error (I cannot remember what it exactly said). Now, it starts up but there is no video and no beeps from POST although I can hear the hard drive spinning up. The Internal Health LED is red.
I am currently doing a RAM upgrade on an HP proliant DL360 G7 server. After installing the new RAM (18x 8GB KTH-PL316E/8G) the LED indicator lights for every single DIMM turned amber and the health check light turned red.
It has 4 hard drive slots and I have 2 Intel 80GB SSDs and 1 WD 160GB regular hard drive. I have tried the WD in all 4 slots and each time it detects it and boots right up into vmware so the slots arn't defective. But when I insert the 2 Intel SSDs the server doesn't see them on POST