Differences

Hi All, This past september I brought an unlocked Experia Play from Europe to Canada. At the time I tried to connect using Bell but they said they don't support the handset because it's too new !

I just flashed my rogers lumia 920 using navifirm with the .1002 ROM because .1001 was not there. Well, phone is working fine, BUT...this new firmware disables AWS 1700!!! My Wind SIM is only connecting in AWAY mode, and when I insert a Rogers SIM, and select manual network selection, both Wind and Mobilicity have disappeared! Only Fido, Rogers, and Bell are showing!!

I have an unlocked Exhibit 2 4G (the Walmart version). I'm planning to go to Canada for 3 months. It seems there are 3 major phone networks there, Bell, Rogers, and Virgin.

Good day,

I have an unlock Samsung galaxy s2 on Android 4.1.2,

It's originally from Rogers, but I've been using it with my Bell sim card for a few months.

This morning after a night charge, my phone wasn't able to read my bell sim card anymore...

I reboot a undred times (almost), Flash the ROM, did it again this time wiping all data on my phone, but nothing changed...

There is no A

doesnt matter what stock rom i use, i used bell telus sasktel no fmc, there still rogers stock apps!! WHY???

I cleared cach dalvik factory reset, everything i can find TWRP , still rogers apps BUT I DIDNT EVEN USE ROGERS STOCK ROM, so the phone used to be rogers

Any idea?? Thanks in advance

After setting the beep preference on Kubuntu 11.10, the beep sound does not change:

$ xset q | grep bell bell percent: 50 bell pitch: 400 bell duration: 100 $ beep $ sudo /usr/bin/xset b 10 400 10 $ xset q | grep bell bell percent: 10 bell pitch: 400 bell duration: 10 $ beep $

The first and second beeps emitted sound the same. Is there something that I am missing?

Telus, Bell, Rogers and Sasktel Via samfirmware

Sent from my SAMSUNG-SGH-I747 using xda premium

Hi Everyone. I have a Samsung Galaxy S3 unlocked, stock ROM and rooted. When i used the phone with Rogers it showed 4G. Now with Bell it shows H+. I am ok with H+ because as i understand this is very similar to Roger's 4G. However, I have never gotten LTE on my phone. Is there a way to enable this? I have checked the APN settings and they seem to be correct as per this forum.

Any ideas?

I am using unlocked Telus SGH-i747m galaxy s iii on fido. The LTE symbol doesn't show up in the notification bar. It shows 4G symbol and then no symbol for a minute and then 4G again. I used the exact same phone/software/rom on Bell and LTE worked just fine before I switched to Fido.

Can I try to use the Rogers stock rom on my Telus phone? Will it brick my phone?