You can use this guide to switch from free drivers to catalyst, after the installation:http://www.chakra-linux.org/wiki/index. … st.2FfglrxMaybe you would have better luck like this.
@dorisYou can follow the steps detailed on Chakra's wiki:http://chakra-project.org/wiki/index.ph … eo-DriversPlease ignore the part about Grub Legacy as for later editions Chakra uses Grub 2. Ask if you run into any issue, good luck!
Hello and welcome to Chakra! To answer no4, no you don't need to overwrite anything with new versions. Chakra is a (half) rolling distribution, so a "sudo pacman -Syu" will always keep you updated with the latest packages.
1. Correct link http://chakra-linux.org/wiki/index.php/ … tion_TableBut do you have a GPT or ms-dos table? If the first, then yes, you will need to create the unformatted space as described in the wiki.2. You can not choose were to install the bootloader ritght now. It installs to the /boot partition of your targer install, or you can choose not to install it, and add Chakr
Hi,I bought whole new PC (with UEFI), and I got some problems with my previous installation of Chakra (didn't boot anymore), so I decided to back up all my stuff and do a clean & new install on my 1TB HDD (that I kept).I deleted all the old partitions, created a GPT partition table the ways the wiki says (http://chakra-linux.org/wiki/index.php/ … tion_Table), using the CLI/ncurses method,
Hello and welcome to Chakra.For starters check the wiki:http://chakra-linux.org/wiki/index.php/ … ur_PrinterYou will probably need to install this package from CCR first:http://chakra-linux.org/ccr/packages.php?ID=1654You can do that with ccr -S brother-mfc210c-cupswrapper