Centos 6.3 Installation error

i have a dell server. its a couple of years old and has a perc 4 raid controller in it. When i do an install it shows the drives configured in the raid 5 configuration. i select the disk and do an auto partition.

I just wanted to get this out there so nobody wastes a whole day like I did. As far as I can tell, the Dell 470 BIOS only gives you an option of RAID ON or RAID OFF.

Hi,I am trying to install Centos 5 on our Wipro Netpower server. It has adaptic SCSI raid-5 controller. When I reach at partion step its gives me error "no device found".Can someone ple... [by Ipreet]

Hi. I am new to the server world and I just installed Centos 6.3 on my Dell PowerEdge 2850. I set up two RAID 1's using the server's RAID controller (Perc 4e). So I have 2 146 GB HDDs in ... [by Nameo0]

Current situation:

Dell PowerEdge T300 server (SAS6/iR controller) (RAID 0/1) Ubuntu 10.04 LTS server installed on software raid (2x500GB) + LVM. Currently used space 25GB.

Questions:

How to make a secure backup of current installation in case of rollback. E.g.

Hi all,

I do not know much about server installation and I hope that someone could give me some help.

We have just purchased 2 x Dell Power Edge R715 with the PERC H700 raid contoller, each machine has 6 x 300GB SAS drives.

I have set 2 drives up in raid 0 and 4 drives in raid 10 on each machine, but when installing ESX4 I cannot see any target disks for the installation.

This is my first time installing ESX4, am I missing something? Do I need a raid driver for ESX4?

I have Dell Poweredge T100 server with Dell SAS 6 and two hard disk on RAID 1.

Last week the server died including one RAID 1 hard disk. We sent the server for repair and the problem with PSU was fixed.

Dear all,I am a new on centos 6.3 installation. I have tried install centos 6.3 on Dell Precision T 1600 and always stop (Hang) at "starting Installation process".Does ... [by susilo]