Did a fresh Database Server installation of CentOS 6.4 on Windows Hyper-V system.The Hyper-V system vNic available to the VM are all VLAN tagged using 802.1q VLAN trunking.1 VLAN ... [by br549]
The traffic from ports eth0.20 and eth0.30 is tagged with VLAN tag 20 and 30, the traffic from port eth0 is untagged. To communicate with the two tagged interfaces, you need a device that can read ... [by dejanst]
I am trying to configure two separate vlans in ESXi. Right now I have two vlan's set up on a single vswitch in separate port groups (one for vlan 100, one for vlan 110). None of the ports connected to the port group for vlan 100 can go anywhere, including the gateway. Everything connected to the port group for vlan 110 works just fine.
Connected to this is an EXSi host with 4 vswitchs each with a VLAN assigned (1-4) connected to one external nic.
Also attached to the HP switch is a SAN file server which is has 2 VLAN compatible NICs.
The port the EXSi is connected to is set to hybrid and has VLAN 1-4 set as tagged with VLAN 1 as the default.
What do I need to do to setup the ports for the SAN so VL
I have a server with 2 nics. I installed Hyper-v 2012 server (not windows server 2012, no gui) I am trying to set up load balancing. I have both nics in the same switch currently in trunk mode and no native vlan.