I just bought a new computer from Costco, got Arch working, and wiped Win8.1. I'm having issues getting bluetooth working, however. I followed the instructions on the bluetooth guide (https://wiki.archlinux.org/index.php/bluetooth) with no luck. when I run bluetoothctl, it says there's no default device.
Hi,I'm installing Arch on my desktop following the installation in the software raid and LVM section (https://wiki.archlinux.org/index.php/So … ID_and_LVM). I'm using RAID1. I've followed the important instructions on the LVM page (https://wiki.archlinux.org/index.php/LVM#Important).
Things should be working as outlined in the wiki: https://wiki.archlinux.org/index.php/Sy … managementIf you think it's important, you can add a line about halt, although it's already mentioned in systemd FAQ https://wiki.archlinux.org/index.php/Sy … r_stays_onThere's also https://wiki.archlinux.org/index.php/Al … o_ShutdownObviously you can use an alias e.g.alias halt='sudo sy
Network and Xorg issues sounds to me like you did too much in one go.https://wiki.archlinux.org/index.php/Be … leshootingCheck the connection, check the driver status and load the module: https://wiki.archlinux.org/index.php/Ne … figurationIf the network interface doesn't show up (eth0), read this part: https://wiki.archlinux.org/index.php/Ne … Interfaces
Hi everyone!I decided to make a fresh install of Arch linux on my laptop as the new installation media came out (so there was a working Arch linux on it since 2009, and now I want to make a dual-boot with Windows Vista), but I got stuck on the beginning during the install.
Firstly I’d like to mention that this guide will not show you how to install Arch from scratch as there is already good documentation which tells you to do so, please read the full beginners guide here if you would like to set up Arch for the first time. This guide assumes you already have a command line system installe
karol wrote:Where did you find the instructions to run 'nano /etc/rc.conf'?Follow the Arch wiki and not any external sources, YT tutorials etc. Arch now uses systemd and not initscripts and there's not rc.conf anymore.https://wiki.archlinux.org/index.php/Rc.confhttps://www.archlinux.org/news/final-sy … n-warning/Arghh.