4

Anybody have any idea why an installer would quit all of the sudden...

view full story
linux-howto

http://www.linuxquestions.org – I was doing a pxe install of slackware 13.0. The computer booted up perfectly, setup partitions, swap, and went into the setup to choose the source. I chose nfs and it successfully found the slackware.iso. It did a full install and it installs fine, then about halfway it just says 'Killed' or sometimes it just goes blank and stops installing those packages. I've tried like 5 times, same result each time(at different packages too). I currently have two sticks of ram inside, so I removed one and tried again, same error. I then shorted the install by only installing the main stuff and it was able to complete. Asked me to setup the mbr and I was all set. Any idea on why the installer would just yack like that? (HowTos)