I have installed Ubuntu 10.04 (64 bit desktop version) on VMWare player over Windows 7 host (64 bit). I am unable to access network. apt-get fails and I am unable to browse the internet. I tried re-installing VMWare tools..it didn't help. I am new to Virtualization and networking. Can someone please help me out?
So here's the scenario:
Network A is the physical network (10.1.1.x 255.0.0.0) which is connected to the internet via the gateway at 10.1.1.1.
Network B is a 'virtual' (VMWare Workstation) network using the IP range 172.16.0.0 255.255.255.0 and the VMware DHCP server.
The goal is to create a virtualized network on Network B that can be routed to directly from Network A, but only through a virtual
I have a VPS on which I installed VMware Workstation version 9. Now I have 3 valid IPs:
XXX.152.193.66
XXX.152.193.101
XXX.152.193.103
Gateway: XXX.152.193.65
Now two IPs are set on the host and I want to have 1 IP set on the VM.
I am running Ubuntu Linux image in VMWare. The host is Windows XP.
There are two network adapters configured in VMWare - one is host-only and the other is bridged. Everything works fine as long as the host does not lose network connectivity.
If the host loses connectivity (even briefly) and then re-acquires it, my bridged adapter in VMWare is still unable to get an IP address.
I installed VMWare player just to play with it.
Everything was good until my PC crashed going into suspend mode.
When I rebooted, my network was disabled.
when I typed
ip addr
There were no eth0 adapters there, but there were a vmnet1 and a vmnet8
Much later I solved this problem by going to Network connections in the Ubuntu System menu, adding a wired connection, and then enabling the network
I downloaded vmware player 4.04 and run into the problem of virtual network device fail.
After googling a bit, I found How do I install VMware Player 4.0.3? and applied as this answer suggest, which is the following:
1) I downloaded the tarball http://weltall.heliohost.org/wordpress/wp-content/uploads/2012/01/vmware...
2) Change the plreqver=4.04
3) and run it.
I installed CentOS 6.3 Minimal on VMWare Player, and I realized how 'minimal' the setup is...
Don't have network connectivity. From what I searched on google, I need to edit the file
/etc/sysconfig/network-scripts/ifcfg-eth0
but since I don't have any editor installed (as far as I know), I don't know how to edit the file.
How do I edit the file????
We've a Windows Server 2008 host on VMware ESXi 4 and want to isolate it from the rest of the network. That is, I want no traffic from the Windows Server 2008 to be allowed on the normal network.
I am having trouble with VMware Player 4.0.3 for Linux. I am trying to run a linux virtual machine guest (from the linux host), but am unable to successfully get an IP address on the guest with bridge networking. I do have an internet connection and I already ran vmware-netcfg and changed the bridge mode from "Automatic" to my sepcific network card.
Email this page
