I've decided to start using Centos again and the last time i installed it was with ver 5.The isos provided then were a liveCD non install, six CD and a DVD -- iirc. When one instal... [by jessejazza]
I started off with a minimal installation of CentOS because I wanted to set up a display manager and window manager on my own. I installed i3 successfully from EPEL repositories (which I installed using the instructions at this link: http://www.rackspace.com/knowledge_c...entos-5x-or-6x ). I successfully launched i3 using `startx`.
I've noticed when booting up Ubuntu 13.10 – Desktop X86-64 disc in "Try Without Installing" mode that Gparted is pre-installed, however if you install Ubuntu to your hard drive the package is removed (or purged? not sure which) during the installation process.
I want to add some drivers to the CentOS LiveCD. These drivers are not present on out of the box CentOS LiveCD.
So Once I add the the new drivers to the LiveCD, and then boot up the server with the LiveCD then I am hoping that it will recognize the new hardware.
I have been googling around this but haven't found a process by which I could add the drivers to a CentOS LiveCD.
My ubuntu doesn't boot. Firstly I installed it using wubi, but then I decided to delete it for some reason. However, after installation using a liveCD, with three partitions, it doesn't boot. Still, it works with liveCD, and I downloaded boot-repair, which didn't help at all. Also, in a liveCD mode I can't save anything, after restart, all changes are in default.